Fab & Fix Balmoral UPVC Door Handle Pair 92mm 62mm PZ 211mm Fixings Lever Snib

UPVC Door Handle Set White 92mm 62mm Lever Snib 211mm Fixings Balmoral

The BALMORAL 92 PZ lever/lever Snib door handle set comes with a high quality finish that is made to endure giving you years of use. The Snib is a small turn knob that holds the latch open, thus preventing the door from latching. You may well find that your existing handle has the Snib located on the side of the handle, this really doesn't matter as our handle with the Snib located on the front will replace this type perfectly. The sprung levers are fixed to the backplate and by design the handles are fully reversible. Fixing lugs are supplied on both backplates for a secure fit. Supplied with fixing screws, fitted return springs and spindle to suit door thickness 58mm to 72mm.

You may want to update your existing cylinder locks at the same time as replacing your handle. A range of locks is available from our shop to suit all budgets including Anti Snap, Anti Bump, Keyed Alike & Thumb Turns.

Features:

• With Snib operation (The Snib is a small turn knob that holds the latch open, thus preventing the door from latching)
• Supplied as a pair complete with spindle and screws
• Universal handing, levers are fully reversible by design
• Sprung version as standard
• Tested to over 200,000 cycles

What's in the pack?

1 x Set of Balmoral White 92PZ Lever Snib Handles

2 x Spindles

4 x Fixing Screws

Dimensions:

• PZ Centres: 92mm & 62mm
• Centre of Snib: 54mm above handle centre
• Backplate width: 32mm
• Backplate length: 243mm
• Lever length: 120mm
• Distance between screw hole centres: 211mm
• For doors from 58 - 72mm thick
• Spindle Size: 8mm

What measurements should I check before ordering a handle set?

The most important measurements are the distance between screw holes centre to centre (this handle measures 211 mm) and the distance from the centre of the handle spindle to the centre of the barrel (this handle measures 92mm). The length and width of the handle are less critical as a slightly shorter or longer handle should make no difference.

Important please check the critical measurements in the diagram in the gallery before ordering.

What does sprung mean?

Sprung means a spring is fitted to the door handle to return the handle to position. The easiest way to determine if you need a sprung or un-sprung handle is to first remove your handle, then operate the lever to see if there is a return spring fitted to the handle. An un-sprung handle can be replaced with a sprung handle, however if your existing handles are sprung they must be replaced with the same.